Stainless Steel Stacked Sludge Dewatering Press Introduction
Equipped with the electric control panel, the Sludge Dewatering Machine can run automatically. Saving lots of labor, it is now widely used in China to replace filter press in the following industries including chemical, paper-making, pharmacy, leather and etc. The Sludge Dewatering Machine can run automatically for 24 hours without looking compared to traditional types, the machine produced by Hengye are of high quality, material and component we choose are all with best quality, so as to guarantee the quality and provide best service to our clients.
Thickening: When the shaft is driven by the screw, moving rings around the shaft move up and down relatively. Most water is pressed out from the thickening zone and fall down to the filtrate tank for gravity.
Dewatering: The thickened sludge moves forward continuously from the thickening zone towards the dewatering zone. With the pitch of the screw shaft thread getting narrower and narrower, the pressure in the filter chamber increases higher and higher. In addition to the pressure generated by the back-pressure plate, the sludge is greatly pressed and dryer sludge cakes produce.
Stainless Steel Stacked Sludge Dewatering Press Advantage
1.Fully Automatic Control
Combining with the auto control system, the machine runs very safely and simply and can be programmed according to the requirement of the users. It can operate automatically for 24 hours, unmanned.
Self-cleaning with small amount of water.
3.No secondary pollution
Only need a small amount of water for self-cleaning, no secondary water pollution. Sludge runs at a slow operating condition. The smell does not spread.